INTUO E 01-K Gebrauchsanleitung Seite 19

vARNISHED FRoNTS
CoLoR vARNISH AND GLoSSY CoLoR vARNISH
in several stePs, Water-baseD varnisH is carefully aPPlieD to tHe surfaces of varnisHeD fronts. in
Water-baseD varnisHes, a large Part of tHe organic solvents are rePlaceD WitH Water. tHis Makes
tHeM alMost oDour-free, eco-frienDly anD non-DetriMental to your HealtH. a furtHer aDvantage
of Water-baseD varnisHes is its esPecially HarD surface. HoWever, varnisHeD surfaces Must be
cleaneD carefully, Preferably WitH norMal HouseHolD cleansers or WitH lukeWarM Water, soMe
DisHWasHing liQuiD anD a soft cotton clotH. sPots anD sPills Must be reMoveD iMMeDiately before
tHey Dry. Water sPots can be avoiDeD by WiPing tHe surface WitH a Dry, soft clotH after cleaning.
stubborn sPots like fat sPlatters or glue resiDue can be reMoveD WitH a stanDarD cleanser for
cleaning Plastics. before use, test tHe cleanser on a HiDDen sPot (e.g. tHe inner siDe of tHe Door).
cHiPPeD Paint causeD by Wear is no grounDs for coMPlaint.
vARNISHED FRoNTS
STRUCTURE vARNISH SURFACES
structure varnisH façaDes are very carefully furnisHeD WitH HigH-Quality Water varnisHs tHat
contain granulate Material aDDitives anD tHe Work is carrieD out in several stages. in Water var-
nisHs a large Portion of tHe organic solvent is rePlaceD WitH Water. tHat is WHy tHey are loW-
oDour, environMentally frienDly anD non-HazarDous to HealtH! anotHer aDvantage WitH Water var-
nisHs is tHeir MarkeD surface HarDness.
HoWever, sucH varnisH surfaces reQuire sPecial care anD cleaning, Preferably WitH lukeWarM Wa-
ter, soMe WasHing-uP liQuiD anD a soft clotH (cotton). sPills Must be reMoveD iMMeDiately before
tHey Have a cHance to Dry. leftover Moisture is PreventeD by WiPing WitH a Dry, soft clotH.
Due to tHeir grainy (granular aDDitives) surface structure, varnisH surfaces tenD to becoMe Dirty
More raPiDly tHan sMootH surfaces. tHerefore, Dirt Must be reMoveD iMMeDiately.
stubborn sPots, sucH as grease sPots, can be reMoveD WitH a very soft brusH, using a coMMon
WasHing-uP liQuiD anD WarM Water. Warning: HarD rubbing Will create glossy areas on structure
varnisH surfaces. care Must be taken to test sPecial varnisH cleaning agents on an inconsPicuous
area Prior to first use (e.g. an inner siDe). sPalling of varnisHeD surfaces causeD by iMPact anD
sHock stresses cannot be consiDereD grounDs for registering a coMPlaint.
036-037 EN
abrasive cleansers or PolisHes, as Well as
HarD, scratcHy sPonges or brusHes are not
suitable for cleaning varnisH fronts. never
use cleansers tHat contain acetone, cHlorina-
teD HyDrocarbon, Paint tHinner or solutions
tHat begin WitH tHe syllables "tri" or "tetra".
WHile cooking, Make sure tHat any extra steaM
is extracteD WitH a cooker HooD. in tHe long
run, Heat anD steaM can DaMage aDjacent units,
fronts or eDges, in sPite of tHe use HigH-Quality
Materials anD Meticulous WorkMansHiP. DaMage
tHat is causeD by iMProPer use is not consiDereD
grounDs for coMPlaint.