INTUO E 01-K Gebrauchsanleitung Seite 20

GLASS FRoNTS
SATINED AND CoLoR-vARNISHED
tHe surfaces of satineD glass fronts are MaDe of HigH-Quality genuine satineD glass (no varnisH
or foils) tHat are cHaracterizeD by tHeir Durable anD HarD-Wearing surface. any glass cleaner is
suitable for cleaning tHe glass. cleansers WitH oily ingreDients sHoulD never be useD, since tHese
Will leave sPots on tHe satin surface tHat are HarD to reMove. tHe insiDe of color-varnisHeD glass
fronts sHoulD be cleaneD like tHe varnisHeD fronts. tHe best MetHoD is to use lukeWarM Water, a
bit of DisHWasHing liQuiD anD a soft cotton clotH. sPots anD sPills Must be reMoveD iMMeDiately so
tHey Do not Dry on tHe surface. to avoiD Water sPots, WiPe WitH a Dry, clean clotH after cleaning.
stubborn sPots like fat sPatters or glue resiDue can be reMoveD WitH a stanDarD cleanser for
Plastics. before use, test tHe cleanser on a HiDDen sPot (e.g. tHe inner siDe of tHe Door). cHiPPing of
varnisH Due to iMPact is not consiDereD grounDs for coMPlaint.
We recoMMenD cleaning WitH coMMercially available WinDoW cleaner anD (for color-varnisHinner
siDes) neuPol rosa.
CERAmIC FRoNTS
NIEvE/IRoN CoPPER
ceraMic fronts consist of a 3.5MM tHick ceraMic inlay in a MitreD aluMiniuM fraMe anD are availa-
ble in tWo colour coMbinations: nieve anD iron coPPer. attention: tHe base Material of ‚nieve' May
contain tiny Particles. tHese can aPPear as sMall, fine Dots WHicH vary in size anD freQuency. as We
Have no influence over tHis, it sHoulD not rePresent a reason for coMPlaint.
ceraMic fronts are absolutely easy to clean, scratcH anD cut resistant (excluDing ceraMic kni-
ves), Hygienic anD uv resistant. as ceraMic is a virtually coMPletely sealeD surface, no Water-Proo-
fing is necessary. staining is not Possible.
all stanDarD kitcHen Detergents can be useD for Daily care.
038-039 EN
abrasive cleansers or PolisHes, as Well as
HarD, scratcHy sPonges or brusHes are not
suitable for cleaning color-varnisHeD glass
fronts. WHen cleaning tHe inner siDe of color-
varnisHeD glass fronts, Do not use Microfibre
clotHs on tHe varnisH siDe. never use clean-
sers tHat contain acetone, cHlorinateD HyDro-
carbon, Paint tHinner or solutions tHat begin
WitH tHe syllables "tri" or "tetra".
WHile cooking, Make sure tHat any extra steaM
is extracteD WitH a cooker HooD. in tHe long
run, Heat anD steaM can DaMage aDjacent units,
fronts or eDges, in sPite of tHe use HigH-Quality
Materials anD Meticulous WorkMansHiP. DaMage
tHat is causeD by iMProPer use is not consiDereD
grounDs for coMPlaint.