Technical Data; Installation - Zanussi ZTB 261 Benutzerhandbuch

Technical data

Height x width x depth
Drum volume
Depth with loading door open
Height can be adjusted by
Weight when empty
Loading volume (depends on programme)
Voltage
Required fuse
Total power
Energy efficiency class
Energy consumption (7 kg of cotton, pre-drained at 1000
2)
rpm)
Average annual energy consumption
Use
Permissible ambient temperature
The consumption values have been established under standard conditions. They may deviate when the machine is
Programme
COTTON CUPBOARD DRY
2)
COTTON IRON DRY
SYNTHETICS CUPBOARD DRY
1) Different loading volume data may be needed in some countries as a result of different measuring methods.
2) in accordance with EN 61121

Installation

Appliance positioning
• It is recommended that, for your convenience, the ma-
chine is positioned close to your washing machine.
• The tumble dryer must be installed in a clean place,
where dirt does not build up.
• Air must be able to circulate freely all round the appli-
ance. Do not obstruct the front ventilation grille or the
air intake grilles at the back of the machine.
1)
Consumption values
operated in domestic circumstances.
2)
2)
85 x 60 x 58 cm
108 l
109 cm
1.5 cm
approx. 32.5kg
max. 7 kg
230 V
10 A
2200 W
C
3.9 kWh
262.6kWh
Domestic
+ 5°C to + 35°C
Energy consumption in kWh / average drying time in min.
(7kg load pre-drained at 1000 rpm)
3.9 / 115
(7 kg load pre-drained at 1000 rpm)
3 / 85
(3 kg load pre-drained at 1200 rpm)
1.18 / 35
• To keep vibration and noise to a minimum when the
dryer is in use, it should be placed on a firm, level
surface.
• Once in its permanent operating position, check that
the dryer is absolutely level with the aid of a spirit level.
If it is not, raise or lower the feet until it is.
• The feet must never be removed. Do not restrict the
floor clearance through deeppile carpets, strips of
wood or similar. This might cause heat built-up which
would interfere with the operation of the appliance.
11