Replacing Of The Illuminant - Schaub Lorenz SL210BDD Bedienungsanleitung

Do not use any steam cleaners to clean or defrost the appliance. The steam can get
into contact with the electrical parts and cause an electrical short.
Manual defrosting (freezing compartment)
1. Remove the contents from the freezing-compartment and put them into a
cooling box.
2. Place a container in front of the appliance to catch the water.
3. Switch off the appliance by turning the thermostat to position 0/AUS/OFF and
disconnect it from the mains.
4. When the encrusted ice melts put some dry cloths into the freezer-compartment
to hold the water back.
5. Remove the big pieces of ice first.
6. Afterwards remove the small pieces of ice.
7. Wipe and dry the appliance and door seals with dry and soft cloths.
8. After cleaning leave the door open for some time to ventilate the appliance.
9. Finally restart the appliance as described in chapter THERMOSTAT AND
OPERATION.
Automatic defrosting (cooling compartment)
1. The cooling compartment is defrosted automatically. The water runs into a
container near the compressor.
2. If the automatic defrosting does not meet the requirements, e.g. on days with
high ambient temperatures and humidity, defrost the appliance manually as
described above.
NOTICE!
WARNING! Switch off the appliance and disconnect it from the mains
1.
before you clean or maintain it.
2. Unscrew the illuminate-cover (1) and remove it (→).
3. Turn the illuminate anti-clockwise to remove it.
4. Insert a new illuminate of the same kind and power (2W).
5. Reinstall the illuminate-cover.
6. Connect the appliance to the mains and switch it on.
According to the EU regulation No. 244/2009 your appliance is classified as a
Defrosting
WARNING!
Risk of electric shock!
Never use mechanic devices, knives or other sharp-edged
items to remove encrusted ice inside the appliance.

Replacing of the illuminant

37