Refrigerant Circuit - Schaub Lorenz SL210BDD Bedienungsanleitung

3. All modifications of the electrical mains to enable the installation of the
appliance must be performed by a qualified professional.
4. Do not use an extension cord or multiple sockets.
5. Check that the appliance does not stand on the power cord after installation.
6. Do not carry out any modifications of your appliance.
7. If the power cord is damaged, it must be replaced by the manufacturer or its
service agent or a similar qualified person in order to avoid any kind of hazard.
8. Do not attempt to repair the appliance alone. Repairs carried out by
unauthorized persons can cause serious damage. Always contact the nearest
service centre and use original spare parts only.
9. Do not use any electric appliances inside the food storage compartments of
your appliance unless they are recommended by the manufacturer of your
refrigerator.
10. Do not put any heat-radiating appliances onto your appliance.
11. Do not put a water-boiler or vases onto your appliance. The electrical
components of your appliance can be seriously damaged by water over-boiling
or spilled water.
Do not damage the refrigerant circuit. The appliance uses the environmental-
1.
friendly refrigerant R600a. The refrigerant R600a is flammable !!! Therefore
the cooling circuit must not be damaged in any way neither by transport
nor use.
If any part of the cooling circuit is damaged, the appliance must not stand
2.
near a fire, naked light or spark-generating devices. Contact your after sales
service immediately.
If gas is set free in your home:
3.
Open all windows.
Do not unplug the appliance and do not use the control panel or
thermostat.
Do not touch the appliance until all the gas has gone.
Otherwise sparks can be generated which will ignite the gas.
Keep all components of the appliance away from fire and other sources of
4.
ignition when you dispose of or decommission the appliance.
The air vents of the appliance or its built-in structure (if the appliance is
1.
suitable for being built-in) must be completely open, unblocked and free of any
kind of dirt.
The condenser and the compressor, located at the rear of the appliance, can
2.
reach high temperatures during ordinary operation. Carry out the installation
according to this manual. An insufficient ventilation of the appliance will impair

Refrigerant circuit

Ventilation
30