Lamp Change - SCHOTT KL 1500 HAL Gebrauchsanweisung

KL 1500 HAL / KL 1500 H - Operating instructions

3. Lamp change

!
Safety information:
ATTENTION!
Please ensure that the lamp and lamp socket have cooled down before replacing the lamp. A
warning sign has been attached to remind you of this necessity.
Please ensure that the light source is switched off and the power plug is pulled out.
Please be careful not to grasp into the device. There is a risk of injury by the trailing fan.
Open the lamp compartment (9) by pressing down and pulling at the designated recess and pulling
the compartment out as far as it will go. Move the lamp including socket up and out of the holder.
Carefully pull the defective lamp off the socket and slip on a new lamp (use a lamp that corresponds
to the specifications given under Point 6.4). Proceed by pressing down on the lamp until it snaps
into place inside the holder. Slide the lamp compartment back in until it locks (audibly) into place.
Insert the power plug and switch on the light source.
Replacing the lamp socket:
The high quality lamp socket is guaranteed to last for 20,000
operating hours or 20 lamp replacements.
When replacing the lamp socket, start by carefully pulling off the
lamp as described above. Use a screwdriver to loosen both
fastening screws at the top of the clip and remove the
component completely. Thread the two cable ends of the socket
(spare part, see Point 6.4) into the corresponding openings on
the clip and retighten the screws (making sure they are seated
firmly). Slip the lamp back on and press it into the holder as
described above.
11/15