Channel - Stereo Frontsystem With Mono Subwoofer - Hifonics ZEUS ZX9000 Bedienungsanleitung

4-Channel Amplifier Speaker wiring and Connections
3-Channel - Stereo Frontsystem with Mono/Subwoofer
X-Over-(Frontsystem 1&2Channel)
• When you use bigger speaker systems (Ø20cm plus),set on FULL RANGE-position (FULL RANGE).
• When you use smaller speaker systems (Ø8.7cm - Ø16cm), set on HIGHPASS- position (HIPASS). The cut-off frequency should be between 60Hz -
150Hz. It is controlled by the HIPASS-regulator(1&2 Channel) . When you use this configuration the LOPASS CONFIG(1&2 Channel) - Switch is out of
function.
X-Over- (Subwoofer 3&4Channel)
• In Mono/Subwoofer-mode you should choose the LOWPASS-position (LOPASS), so the higher frequencies are cut off. The cut-off frequency should be
between 60Hz - 100Hz. It is controlled by the LOWPASS- regulator.
• In lowpass-position(LP/BP) the Highpass-regulator (HI PASS) is activated as Subsonic-Filter . Subsonic frequency should be between 15Hz - 40Hz,
depending on the size of the installed speaker.
Level-
• Turn the INPUT LEVEL control on the amplifier to 6V position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT LEVEL control clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL control slightly until you can hear clean sound.
Bass EQ-
• Frontsystem 1&2 Channel - Bass EQ should be set on 0dB-position
• Subwoofer 3&4 Channel - Allows you to adjust bass boost from 0dB up to +18dB.
Caution! Please use the Bass-Boost carefully. The additional boost may result in clipping or overload.
Mode-
• If there is only one RCA output at your head unit , set mode-switch on 2CH-postion.
Connect RCA Cable from
head unit with RCA inputs
(INPUT CH1/CH2 &
CH3/CH4).
HIFONICS HIFONICS
POWER PROTECT
0dB 18dB
HFR-1
Remote Control -
Connection for remote
control.Allows you to
adjust the subwoofer
from your seat
32
ZX-6400 / ZX-8400
Interconnect cable checklist:
• Connect the LINE INPUT (FRONT IN L&R / REAR IN L&R) of the amplifier to the head unit line output with good
quality RCA to RCA cables.
• Connect the front speaker with speaker outputs (+ CH1 -, + CH2 -) and the subwoofer with the speaker outputs (+
of Ch3 and - of CH4) of the amplifier.
•The minimum final speaker impedance must not be below 2 Ohm per channel. Too low speaker loads result in too
high heat dissipation and may cause the amplifier run into protection.
• Please observe speaker channel and polarity as printed by the speaker terminal block.Incorrect phasing of the
speakers results in total loss of bass response.
Be careful not to connect speaker (-) to the ground or vehicle chassis.
Caution!
Subwoofer 4 - 8 Ohm
Front speaker 2 - 8 Ohm