Channel - Mono Subwoofer - Hifonics ZEUS ZX9000 Bedienungsanleitung

4-Channel Amplifier Speaker wiring and Connections
2-Channel - Mono/Subwoofer
X-Over-(1/2 & 3/4 Channel)
• In Mono/Subwoofer-mode you should choose the LOWPASS-position (LOPASS), so the higher frequencies are cut off. The
cut-off frequency should be between 60Hz - 100Hz. It is controlled by the LOWPASS- regulator.
• In lowpass-position(LP/BP) the Highpass-regulator (HI PASS) is activated as Subsonic-Filter . Subsonic frequency should
be between 15Hz - 40Hz, depending on the size of the installed speaker.
Level-
• Turn the INPUT LEVEL control on the amplifier to 6V position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT LEVEL control clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL control slightly until you can hear clean sound.
Bass EQ-
• Allows you to adjust the bass boost from 0dB up to 18dB
Caution! Please use the Bass-Boost carefully. The additional boost may result in clipping or overload.
Mode-
• Should be set on 2CH- position.
Connect RCA cabels
from head unit with RCA
inputs (LINE INPUT
1CH/2CH).
ZX-6400 / ZX-8400
Interconnect cable checklist:
• Connect the LINE INPUT of the amplifier to the head unit line output with good quality RCA
to RCA cables.
• Connect the speakers with the terminal block (+MONO-) of the amplifier.
•The minimum final speaker impedance must not be below 2 Ohm per channel. Too low
speaker loads result in too high heat dissipation and may cause the amplifier run into
protection.
• Please observe speaker channel and polarity as printed by the speaker terminal block.
Incorrect phasing of the speakers results in total loss of bass response.
Be careful not to connect speaker (-) to the ground or vehicle chassis.
Caution!
Subwoofer 4 - 8 Ohm
Subwoofer 4 - 8 Ohm
31