Safety Warnings - Megger M5097 Bedienungsanleitung

SAFETY WARNINGS

Measurements beyond the maximum selected range must not be attempted.
Extreme care must be taken when measuring above 50 V, especially on live bus-bars.
To measure voltage, the instrument must not be switched to a current or resistance range, or to the diode check position.
Circuits must be de-energised and isolated before carrying out resistance tests.
The rotary selector switch must only be turned after removing test connections.
All external voltages must be disconnected from the instrument before removing the battery.
Test leads, prods and crocodile clips must be in good order; clean, and with no broken or cracked insulation.
UK Safety Authorities recommend the use of fused test leads when measuring voltage on high energy systems.
Replacement fuses must be of the correct type and rating.
The instrument must not be used if any part of it is damaged.
Warnings and precautions must be read and understood before an instrument is used. They must be observed during
NOTE
.
THE INSTRUMENT MUST ONLY BE USED BY SUITABLY TRAINED AND COMPETENT PERSONS
2