Manual Tune - Toshiba 20V300P Inbetriebnahmeanweisungen

The television can be tuned-in manually using Manual tuning. For example: if the television cannot be
connected to a media recorder/decoder with a SCART lead or to tune-in a station on another System.
Use left and right to move across the screen and select any of these Manual Tune options.
Programme
Programme: The number to be pressed on the remote control.
System: Specific to certain areas.
Colour system: Factory set to Auto, should only be changed if problems are experienced, i.e. NTSC input
Channel: The channel number on which a station is being broadcast.
Programme skip:
Search: Search up and down for a signal.
Manual fine tuning: Only used if interference/weak signal is experienced. See page 22.
To allocate a programme position on the television for a decoder and media recorder: turn the decoder on,
insert a pre-recorded film in the media recorder and press PLAY, then manually tune until found.
Press MENU and using left or right select the
1
SET UP menu, with down highlight Manual
tuning, press OK to select.
L a n g u a g e
C o u n t r y
A u t o t u n i n g
M a n u a l t u n i n g
Pr o g r a m m e s o r t i n g
P i c t u r e p o s i t i o n
E X T 2 i n p u t
B a c k
M E N U E X I T
Use up or down to highlight the programme
2
position required e.g. we suggest Prog. 0 for
a media recorder.
M a n u a l t u n i n g
Pr o g r a m m e
0 0 I A
O K S t o r e
M E N U B a c k E X I T
Press OK to select. If the programme is skipped,
3
Programme skip must be removed before
storing.
Press right to select System and use up or
4
down to change if required.

Manual tune

System Colour
system
from external source.
means nothing has been stored or the facility to skip the channel is ON. See page 12.
S E T U P
E n g l i s h
U K
OK
OK
OK
OK
C V B S
Wa t c h T V
C 6 0 0
Wa t c h T V
Programme
Channel
skip
0 0
S t o r e
O K
M E N U B a c k
Then press right to select Search.
5
Press up or down to begin the search. The
6
search symbol will flash.
0 0
S t o r e
O K
B a c k
M E N U
Each signal will show on the television, if it is not
7
your media recorder, press up or down again to
restart the search.
When your media recorder signal is found, press
8
OK to store.
Repeat for each programme position you want
to tune. Press EXIT when you have finished.
P N
LEASE OTE
Select the Manual tuning screen in Step 2. Enter the
Programme number, the System, then the
Channel number. Press OK to store.
11
Search Manual fine
tuning
M a n u a l t u n i n g
S y s t e m
I A C 6 0
E X I T Wa t c h T V
M a n u a l t u n i n g
S e a r c h : U p
I A C 6 0
Wa t c h T V
E X I T
This television has direct channel entry
if the channel numbers are known.
0
0