Inhaltsverzeichnis
Werbung
a
b
c
o
f
e
d
Accessoires standard
a) 2 tuyaux de rallonge
b) suceur tissus
c) lave-vitre (trois mesures
différentes)
d) tuyau flexible
e) commande vapeur sur le tuyau
flexible
f) commande aspiration sur le
tuyau flexible (tenir appuyé
pour augmenter ou diminuer
la puissance du moteur)
n
g
p
h
g) lance bec incliné avec suceur
rond en nylon
h) soufflage
i) brosse articulée multi-usage
l) châssis-brosse
m) élément rigide
n) châssis-brosse pour lance
o) châssis-brosse pour embout
p) bouteille de remplissage
q) suceurs en nylon pour lance
37
- Switch on the machine at the main switch (4)
Press the red steam-release button located on the
handle and let the condensate and any air contained
i
in the boiler bleed out for about 10 seconds.
Wait until the machine starts raising steam again.
- Press the vacuum function button (f) on the hose handle (d) to
activate or deactivate the blowing function.
l
- Adjust the blowing power via the blower power button (f) on
the hose handle (d). Keep the button pressed to increase or
m
decrease the blowing power.
- For the blowing function, the use of the hose (d) with nozzle
(g) is recommended.
- Switch on the machine at the main switch (4).
- Press the vacuum function button (f) on the hose handle (d) to activate or deactivate the vacuuming
q
function. Fig. 14.
- Adjust the vacuuming power via the vacuum power button (f) on the hose handle (d). Keep
the button pressed to increase or decrease the vacuum power.
- Switch on the machine at the main switch (4) and press the boiler heating button (5). As soon as
the green control lamp ('ready for operation') (8) illuminates, you can work with steam.
- Adjust the steam volume via the handwheel (6) on the appliance; rotate clockwise for more steam,
anticlockwise for reduced steam.
- Push the steam on/off button (e) on the handle of the work hose (d), to activate or deactivate the
steam function. Fig 14.
Proceed as described above and activate both functions simultaneously.
HINTS ON THE USE OF YOUR APPLIANCE
For the deep cleaning of your home, we recommend cleaning with steam at least once a week.
A warning sound will be heard when water in the tank is low. When this happens, you are advised
to refill the tank immediately.
Very dirty floors:
Begin first with the steam cleaning (use the multifunction swivel brush (i) with the rubber lip attachment
(l)). For the cleaning of very dirty floors, first switch on the steam to loosen the dirt. Then stop the
steam and vacuum the floor.
OPERATING THE APPLIANCE
Vacuum cleaning alone
Steam cleaning alone
Simultaneous vacuuming and steam functions
26
f
e
Fig. 14
Werbung
Inhaltsverzeichnis
