Environment Concerns; Declaration Of Conformity - auna KR-200 Bedienungsanleitung

No sound
No network connection
can be established.
WiFi connection cannot
be established
Wired connection cannot
be established.
No station is found
Hiss in FM mode
No stations available /burbling / inter-
mittent in DAB mode.
Alarm does not work.
NetRemote does not show or connect
to KR-200
All other undetermined
cases.
According to the European waste regulation 2002/96/EG this symbol on the product or on its pa-
ckaging indicates that this product may not be treated as household waste. Instead it should be
taken to the appropriate collection point for the recycling of electrical and electronic equipment. By
ensuring this product is disposed of correctly, you will hep prevent potential negative consequences
for the environment and human health, which could otherwise be caused by inappropriate waste
handling of this product. For more detailled information about recycling of this product, please con-
tact your local council or your household waste disposial service.
Producer: CHAL-TEC Vertriebs- + Handels GmbH, Wallstraße 16, 10179 Berlin.
This product is conform to the following European directives:
1999/05/EC (R&TTE)
2011/65/EC (RoHS)
- Turn on the sound as it may be muted
- Increase the volume
- Pull any connected headphone or speaker from the connector jack.
- Check the LAN cable or the WLAN function. - Try to set an IP address at the device.
- Activate the DHCP function on the router and make the connection again at the device
- A firewall is activated on the network — set the respective program in such a way that
access is possible, - Reboot the router
- Check the availability of WLAN network on the router. - Place the device closer to the
router - Make sure the password is correct..
- Check the availability of LAN network on the access point.
- Reconnect or even replace the LAN cable.
- Check the network as well as the access point and firewall. - The station may not be
available currently, try it again later or select another station. - The link of the station is
changed or the station no longer transmits, ask the provider for information.
- The link of manual added station is not correct, make sure it is correct
and re—enter
- Check/move the FM antenna
- Move the radio
- Move the radio. - Rescan local stations only (high-strength). - Check the local DAB
coverage.
- Switch on the alarm. - Due to the volume setting, refer to the solutions of „No sound".
- The source of alarm was set to be station but there is no network connection. -Change the source
of alarm or reconfigure the connection.
- Reopen the App. - If you have several streaming from several devices at the same time, it
may cause crash, reboot KR-200 and/or your device.
- KR-200 may process large amount of data after a period of operation,
no matter in which mode, it will cause the system freeze or malfunction.
Reboot KR-200 if necessary.
- The normal function of the product may be disturbed by strong Electro-
Magnetic Interference. If so, simply reset the product to resume normal
operation by following the instruction manual. In case the function could not
resume, please use the product in other location.
- The device may malfunction when used in areas with strong radio interference. The device will
work properly again once there is no more interference.

Environment Concerns

Declaration of Conformity

40