Banner Timeout; Active Aerial Antenna - Power Supply; Auto Search Function; Manual Search Function - Schwaiger DSR 6006T Bedienungsanleitung

9.3 Banner Timeout

When switching to another station with the
the device) an "Information Box" is displayed for a few seconds at the bottom of the screen. You
can adjust the duration of the display to 2, 4, 6 or 8 seconds in the menu "General Settings" (10 -
"Banner Timeout").

9.4 Active Aerial Antenna - Power Supply

So-called active aerial antennas (indoor or outdoor) are widely used for the reception of digital
terrestrial TV. At the initial operation of the receiver you can switch on the power supply required
for these aerial antennas. The built-in amplifier of the aerial antenna is then automatically powered
by the DVB-T receiver via the connection cable and does not require additional wiring.
You can switch the power supply on or off at any given time from within the menu "General
Settings" (menu item 8). If you have a standard aerial antenna without the need to receive power,
the setting for "Antenna Booster Power" must be set to "OFF".

9.5 Auto Search Function

When you set up your receiver for the first time, an "Auto
Search" process will start automatically. If it should fail for
some reasons or you wish to search for new TV channels,
please follow the steps listed below.
Select "Auto Search" in the "Installation" menu and then
press the OK button.
TV (and radio broadcast channels, if available) will be
searched.
The names of the found channels will be listed.
After the search process has been finished, the unit automatically turns to normal TV viewing
mode.

9.6 Manual Search Function

Use this channel search by entering the multiplex information
manually to the receiver. This channel search is often used to
search for a particular channel or those channels that "Auto
Search" has missed, but it requires comparatively more
expertise.
Select "Manual Search" in the "Installation" menu and then
press the OK button.
Select the multiplexes (TV channel packages) you want to
search, using the
After the settings are completed, press the RED button to start "Manual Search".
The names of the found channels will be listed.
After the search process has been finished, the unit automatically turns to normal TV viewing
mode.

9.7 Delete Channels from Total List

When performing an "Automatic Search" also some unwanted channels may be caught. To delete
individual channels from the "Total List" :
Go to "Channel Manager" and select "Remove Channels fromTotal List".
Select unwanted channel(s) with the
Shift selected channel(s) into the trash can "Recycled", using the
Press GREEN button to move to the trash can "Recycled".
Press OK to shift back channels from trash can to the "Total List", if needed.
Press EXIT to delete all channels from the trash can. A warning message appears.
Press OK for delete, press EXIT to cancel the delete process.
buttons and OK.
buttons and OK.
buttons (on the remote control or the front panel of
button.
GB