Safety Notes - Schwaiger DSR 6006T Bedienungsanleitung

3. Safety Notes

This set top box (STB) has been manufactured to satisfy the international safety standards.
Please read the following safety precautions carefully.
MAINS SUPPLY:
95 to 250V AC (no voltage selection)
OVERLOADING :
Do not overload a wall outlet, extension cord or adapter as this may result in fire or
electric shock.
LIQUIDS :
The STB shall not be exposed to dripping or splashing and that no objects filled with
liquids, such as vases, shall be placed on the apparatus.
CLEANING :
Disconnect the STB from the wall outlet before cleaning.
Use a light damp cloth (no solvents) to dust the STB.
VENTILATION :
The slots on top of the STB must be left uncovered to allow proper airflow to the unit. Do
GB
not expose the STB to direct sunlight or do not place it near a heater.
Do not stack electronic equipments on top of the STB.
ATTACHMENTS :
Do not use any accessories that are not recommended by the manufacturer of this unit
as these may cause hazard or damage the STB.
CONNECTION TO THE ANTENNA :
Disconnect the STB from the mains before connecting or disconnecting the cable from
the antenna.
Failure to do so can damage the antenna.
CONNECTION TO THE TV :
Disconnect the TV from the mains before connecting or disconnecting the cable from the
STB. Failure to do so can damage the TV.
GROUNDING :
The antenna cable MUST BE EARTHED to the system earth of the antenna.
The grounding system must comply with national standards for electrical safety.
LOCATION:
The STB is designed for indoor use only. Do not expose it to lightening, rain, or direct
sunlight.
General
Do not remove the cover.
Do not allow the unit to be exposed to hot, cold or humid conditions.
Do not connect or modify cable when the STB is plugged in.
Use a soft cloth and a mild solution of dish washing liquid to clean the casing.
Never allow liquids, spray or other materials to come into contact with the inside of the
STB.
Service should be carried out only at a authorized service centre, contact your local
dealer for more information.
Please note that the STB will be isolated completely from the 230V mains supply only
after setting the mechanical power switch to OFF (on the rears panel).