Schwaiger DSR 6006T Bedienungsanleitung Seite 34

3. RS-232 Data Interface
Computer interface for service stations and advanced users only. To be used for software update
and channel list data transfer from another receiver (master / slave).
4. S-Video Output
Analog video output for connecting Home Theatre systems through matching input jacks.
5. Analog Video Output
Analog video output for connecting Home Theatre systems or monitors. The available video output
signal format is "CVBS"
6. Digital Audio Output (Coaxial)
Dolby Digital and Linear PCM Stereo output for digital input of a HiFi or A/V system with integrated
digital decoder. (Dolby Digital and Linear PCM Stereo)
7. Analog Audio Output (Stereo)
Audio Stereo L/ R signal for connecting your TV, HiFi or Home Theatre system.
8. SCART Connector (TV)
For connection of all audio and video signals of this digital receiver to the TV set.
9. SCART Connector (VCR)
GB
For connection of all audio and video signals of this digital receiver to a video cassette recorder
(VCR).
10. VHF / UHF Antenna Input
The signal supplied to this connector from a TV antenna (or a local cable TV network) will be sent
to the TV OUT connector.
11. UHF Modulator Output
It provides audio and video signals from this receiver, modulated on a UHF channel of your choice.
If needed, connect the TV / VCR antenna input with a RF cable.
12. VHF / UHF Terrestrial Antenna Input(RF IN)
Connect your antenna to this input jack (RF IN). For so-called "active" antenna systems a suitable
power supply can be provided from this jack (to be selected in the "General Settings" menu, item
"Antenna Booster Power").
13. VHF / UHF Terrestrial Antenna Loop-Through Output(RF OUT)
If you have another analogue or digital receiver and you wish to use the same antenna, then you
can connect it to this "antenna loop-through" output jack (RF OUT)
14. Mechanical Power Switch
Please note that the STB will be isolated completely from the 230V mains supply only after setting
this mechanical power switch to OFF. If the device is not used for a long period of time, we
recommend switching it off completely with this switch and disconnecting it from the power supply
CAUTION:
Do not mix up RF IN and RF OUT jacks when connecting your antenna system.