Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Quicklinks
19. Booth output
E
These jacks are used to connect the mixer to your monitor with RCA cable.
N
20. Record REC output
G
The record output jacks can be used to connect the mixer to the record input of your
L
recording unit, thus enabling you to record your mix with RCA cables.
I
S
21. Phono (PH/N) and line RCA inputs
H
The mixer has 2 PHONO and 2 LINE RCA inputs each channel has two corresponding
lines and can be chosen via the channel line switches. When switched to the PH position
you may use any turntable with a magnetic cartridge, remember to connect your ground
wire (see GROUDING SCREW) or there may be a system hum. And when the switch is in
the LN position you may connect any line level device as described (Mp3, CD,Tape etc).
Now you may plug the RCA's from your playable medium into each input to be connected to
their respective CHANNELS (CH).
22. PC USB
Record file to computer, play file from computer via USB interface.
Noted: Please do not use this device its ports "USB 1"&"USB 2" that connecting with only
one PC/Computer at the same time, if so it will make the PC/Computer is down.
23. Grounding screw
Connect the cord for the analog player's ground. this terminal is exclusively for an analog
player and is not a safety earth.
Technische Daten / Specifications
Eingangspegel / Impedanz - Input level / impedance
CD/LINE ................................................................................. 300mV / 22 k
PHONO ....................................................................................... 5mV / 47k
MAIN MIC ...................................................................................... 5mV / 3k
MIC ................................................................................................ 5mV / 3k
Frequenzeigenschaften - Frequency response
CD/LINE/PHONO/MIC ........................................................... 20Hz to 20kHz
SN ratio
CD/LINE ..................................................................... 86dB (with effects off)
PHONO ................................................................................................. 76dB
MIC ........................................................................................................ 69dB
Klirrfaktor – Distortion rate
CD/LINE/PHONO .............................................................................. < 0.02%
Cross talk ............................................................................................ > 70dB
Klangregelung - Channel 3 band EQ
HI ................................................................................ +12dB, -24dB (12kHz)
MID ............................................................................... +12dB, -24dB (1kHz)
LOW ............................................................................. +12dB, -24dB (70Hz)
Stromversorgung, Betriebsdaten, etc. – misc. Technical data
Versorgungsspannung / net voltage....................... AC 100-240V ~ 60/50Hz
Leistungsaufnahme / Power consumtion................................................ 20W
Betriebstemperatur / Operating temperature......................... +5 ° C to +35 ° C
Luftfeuchtigkeit bei Betrieb / Operating humidity........................... 5% to 85%
Abmessungen / Dimensions.............................. 165 mm x 289 mm x 88 mm
11
Pronomic DX-210 USB DJ-Mixer
Bedienungsanleitung / Users manual
00028156
Version 06/2012
Werbung
Verwandte Anleitungen für Pronomic DX-210
Inhaltszusammenfassung für Pronomic DX-210
- Seite 1 The record output jacks can be used to connect the mixer to the record input of your recording unit, thus enabling you to record your mix with RCA cables. Pronomic DX-210 USB DJ-Mixer 21. Phono (PH/N) and line RCA inputs The mixer has 2 PHONO and 2 LINE RCA inputs each channel has two corresponding lines and can be chosen via the channel line switches.
- Seite 2 Thank you for your purchase of the Pronomic DX-210 USB DJ-Mixer We hope that you will enjoy the use of the Pronomic DX-210 USB DJ-Mixer Please read through this manual carefully before beginning to use, so that you will be able...
-
Seite 3: Vorsichtsmaßnahmen
Bedienungsanleitung 1. Input Selector Switches, Control Knobs, and Peak Level Meters for CH-1 to CH-2 Input selector switches Vorsichtsmaßnahmen These switches select what input source to use from among the units connected to each channel. CH-1a nd CH-2: Switches between LINE/USB/PHONO (input connectors 21 and 22, see below) BITTE SORGFÄLTIG DURCHLESEN, EHE SIE WEITERMACHEN GAIN level control... -
Seite 4: Operation And Functions
Montage: Water warning: • Lesen Sie unbedingt sorgfältig die mitgelieferte Dokumentation durch, die das Verfahren beim Zusammenbau beschreibt. • Do not expose the instrument to rain, use it near water or in damp or wet conditions on it containing liquids which might Wenn das Gerät nicht in der richtigen Reihenfolge zusammengebaut wird, kann es beschädigt werden oder sogar spill into any openings. - Seite 5 Users manual Precautions Please read carefully before proceeding Warning: Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical shock, short-circuiting, damages, fire or other hazards. These precautions include, but are not limited to, the following: Power supply / power cord (devices with power cords/power supplies): •...
- Seite 6 5. CUE-Schalter Schaltet zwischen den zwei Inputchannels. „CH-1“ links wählt Kanal 1, "CH-2“ rechts wählt Kanal 2 6. CUE-Level Regelt den Kopfhörer-Monitor-Sound des ausgewählten Kanals CH-1 / CH-2. Die Master- terlautstärke ist von der Regelung nicht betroffen 7. MIC LEVEL (Mikrofon-Pegel) Regelt die Lautstärke des Mikrofons.