5_First Steps; Battery; 1_Installing And Extracting The Battery; 2_Charging The Battery - RugGear RG100 Schnellstartanleitung

10

5_firSt StEPS

5.1_battery

The battery is inserted into the back of the mobile phone. The
battery is not fully charged when the mobile phone is purchased,
but it contains enough energy to power on the phone.
To obtain best battery performance and battery life, let the battery
discharge completely before charging it completely for the first
three charging cycles.
5.1.1_InStallIng and extractIng tHe battery
When installing the battery, insert the teeth at the top of the battery
into the corresponding notches of the mobile phone, then press
the battery down and secure it by turning the two screws with the
delivered screw driver. Ensure that the battery is safely in place
before powering on the phone.
Quick Start Quick Start
5.1.2_cHargIng tHe battery
Connect the USB-cable with the phone as
Connect the plug with the socket of the
After charging, remove the USB-cable from
5.1.3_battery uSe
In actual use, the standby time and talk time of the phone varies
with the network status, working environment and usage.
When the power of the battery is lower than normal, the phone
will prompt you to charge it. Please charge the battery; otherwise
you may lose any files which have not been saved.
If you do not charge for a long time, the phone will be powered off
automatically.
WarnIng
The phone may only be charged at ambient temperatures in
a range from 0 °C – 45 °C. Please do not use charging equipment
if the temperature exceeds this range. Only use the RugGear
approved USB-cable and charger. Using any other cable may
cause danger and will void the warranty.
indicated in the picture.
power supply.
the charger.
11
En