Charging The Device - Aspire Cygnet Bedienungsanleitung

Charging the Device

Charging
The device is equipped with a micro USB port with a maximum current draw
of up to 1A. Connect the device using the charging cable, so that the display
indicates the device is being charged. As soon as the device reaches the
required voltage or is fully charged, the charging process will stop automati-
cally and the display will turn off.
Note:
• The battery should not be replaced during the charging process. Please
disconnect the charging cable from the device before you replace the battery.
• The charging process cannot be initiated if the battery is not inserted properly.
• If the charging voltage is below 4.2 volts, the display on the box mod will
show "CHECK CHARGER". In this case, please check whether the USB
charging cable is functioning properly.
55