Using The Device; Charging The Device - Aspire Dynamo Mod Bedienungsanleitung

Using the Device

Operating Instructions
Fully charge the two necessary and replaceable 21700/18650 batteries before first use. Please take
note of the positive and negative poles in the battery compartment. Ensure that there is no visible
damage to the surface of the battery cells. The device has a 510-pin connection with a spring-loaded
connector, making it suitable for a variety of clearomizers.
Note for Cleaning
Use a dry cloth or cotton swab to clean the device.

Charging the Device

Connect the device to a PC or notebook via the supplied Micro-USB cable. The maximum charge rate
is 2A. If you connect the Dynamo to the charging cable, the display will show the current charge status
of the batteries. The charging process will stop automatically and the display will switch off once they
are completely charged (4.2V). The batteries CANNOT be changed during the charging process. To
do this, please disconnect the USB connection first. If using a wall adapter, make sure it is suitable for
charging with a current of 5V/2A.
44