Connection Of An Analogue Sensor, For Example A Hsc2-Sensor Including The Appropriate Basic Settings, With Or Without Ex - Sulzer CP 112 Einstell- Und Belegungsanleitung

4
Connection
1 2 3
14 15 16
5 Sensor type
Analogue sensor, for example HSC2
6 Analogue mA1
Scaling 100% = xx,x m
Scaling 0% = 0,0 m
Units [m]
Filter 2s
7 Highwater alarm xx,x m
Dry run alarm xx,x m
Identify value of pump pit and register.
EN
2 Connection of an analogue sensor, for example a HSC2-sensor
including the appropriate basic settings, with or without EX.
Pump 1
4 5 6 7 8 9
17 18 19 20 21 22
.
Pump 1
Table 2 Settings
Selection sensor
Enter end value of sensor
turn until value HSC2
correspond, for example 4,0 m.
Set to 4,0 m
View only
View only
View only
High water level 0-3,5 m
Enter value, for example 2 m
Set to 2 m
Dry run limit value
Enter value, for example -3 m
Set to -3 m
8 21 9
F0 F1 Di
Pump 1
1 2
Start level P1 xx,x m
Stop level P1 xx,x m
8 Func. back pressure [Off ]
9 Start delay. 3s
Stop delay. xx s
10 Alternative Stop level [Off ]
1 3 5 13
L1 L2 L3 NO
A1
0
A2
2 4 6 14
T1 T2 T3 NO
U1 V1 W1
M
3~
PE
High water level
Start level P1
Lowest switch off point
Stop P1
Start one pump
Enter value, for example 0,7 m
Set to 0,7 m
Stop one pump
Enter value, for example 0,2 m
Set to 0,2 m
View only
View only
Enter Stop delay
Enter value, for example.. 3 s
Set to 3 s
View only