Sulzer CP 112 Einstell- Und Belegungsanleitung Seite 11

7 C P T ABS CP 112, A
ONTROL ANEL YPE
10
Alternative stop level [Off ]
11 Nominal current P1 6.0 A
Dry run P1 [Off ]
Current alarm delay. 5 s
12 P1 back up start [Off ]
13 Exercise run P1 [Off ]
Exercice run 1 s
Max. still time 24 h
14 Leakage monitoring.P1 [Off ]
15 Temp. monitoring. P1 [Off ]
16 Buzzer [On]
Backlight time. xx min
C
DJUSTING AND ONFIGURATION
Table 3 Settings
View only
Enter value
I from name plate pump
N
Set to nominal current
View only
View only
View only
Change
Exercise run [On]
Value depends on facility and
has to be checked. Make sure
that pump will not suck air.
Pressure pipe has to be free.
Enter value, for example. 1s
Set to 1 sec
View only
Leakage monitoring
depending on pump type
if present
[Only message]
Temperature monitoring
for EX pumps required
if present
[Manual reset]
Alternative with non Ex and existing
temperature monitoring at the pump.
[Auto reset]
If no temperature monitoring
present - view only
View only
Enter value, for example 5 min
Set to 5 min
G
UIDE
Alarm Relais [Alarm Alert]
Alert on time 10 min
Alert pause time 5 min
Code [Off ]
17 Stations ID
CP 112 Ver: xx.x
18 Mains connection
Alarm relay 1
Selections:
[Alarm alert] = floating alarm contact
[High water] = max. water level
[Activealarm] = only if alarm occurs
View only
View only
View only
1 View only
View only
ESC
EN