Starting Operation; Working Advice - Bosch Uneo Originalbetriebsanleitung

Operation

Starting Operation

Setting the Operating Mode
With the selector switch for drilling/hammer
drilling 4, the operating mode of the machine is
selected.
Note: Change the operating mode only when the
machine is switched off! Otherwise, the machine
can be damaged.
To change the operating mode, turn the selector
switch for "drilling/hammer drilling" 4 to the re-
quested position.
Position for hammer drilling in con-
crete or stone
Position for drilling without impact
in wood, metal, ceramic and plastic
as well as for screwdriving
Reversing the Rotational Direction
(see figure D)
Actuate the rotational direction switch 8 on-
ly when the machine is at a standstill.
The rotational direction switch 8 is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch 9 actuated.
Right Rotation: For drilling and driving in screws,
push the rotational direction switch 8 left to the
stop.
The indicator for right rotation 6 lights up
when the On/Off switch 9 is actuated and
the motor is running.
Left Rotation: For loosening and unscrewing
screws and nuts, press the rotational direction
switch 8 through to the right stop.
The indicator for left rotation 7 lights up
when the On/Off switch 9 is actuated and
the motor is running.
Bosch Power Tools
Switching On and Off
To start the machine, press the On/Off switch 9
and keep it pressed.
To switch off the machine, release the On/Off
switch 9.
For low temperatures, the power tool reaches
the full hammer/impact capacity only after a cer-
tain time.
Setting the Speed/Impact Rate
The speed/impact rate of the switched on power
tool can be variably adjusted, depending on how
far the On/Off switch 9 is pressed.
Light pressure on the On/Off switch 9 results in
low speed/impact rate. Further pressure on the
switch increases the speed/impact rate.
Battery Charge-control Indication
The battery charge-control indicator 5 indicates
the charge condition of the battery for a few sec-
onds when the On/Off switch 9 is pressed
through halfway of fully.
LED
Continuous lighting, green
Continuous lighting, red
Temperature Dependent Overload Protection
When using as intended for, the power tool can-
not be subject to overload. When the load is too
high or the allowable battery temperature of
70 °C is exceeded, the electronic control switch-
es off the power tool until the temperature is in
the optimum temperature range again.
Additionally, the battery charge-control indicator
5 flashes green and red at the same time until the
On/Off switch 9 is released.

Working Advice

Apply the power tool to the screw/nut only
when it is switched off. Rotating tool inserts
can slip off.
English | 21
Capacity
> 30%
≤ 30%
2 609 002 670 | (2.6.08)