Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Use
• Detailed DMX Values per Channel
Channel
1
2
FLASH DURATION
3
4
INTENSITY: Set the flash intensity from minimum (blackout) up to maximum using the intensity fader. The maximum
intensity is reduced in low power mode.
FLASH RATE: Set the flash rate from 0 to 25 flashes per second using the flash rate fader. Switch the flashing on
and off with the run/stop button (red LED when switched on, green LED when switched off).
CHASE/SYNC: The chase/sync button toggles between staggered and simultaneous flashing of multiple fixtures.
The LED blinks in chase mode and remains steady in sync mode.
BLINDER EFFECT: The blinder effect is controlled through the momentary blinder effect button. The lamp power is
electronically regulated to prevent the lamp from overheating.
SINGLE FLASH: Press the single flash button to select the single flash mode with continuous flashing stopped. The
flash rate cycle can be restarted by pressing the single flash button while continuous flashing is running.
• DMX512 Connection
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the VDP3000ST. Multiple VDP3000STs can be linked through serial linking. The linking cable
should be a two-core screened cable with XLR input and output connectors.
VDP3000ST
Function
From
0
INTENSITY
6
0
0
FLASH RATE
6
0
6
43
EFFECTS
86
129
172
215
To Description
5
Blackout
255 Intensity from 0 ~ 100%
255 From 0 ~ 530ms
5
No rate
255 From 0.6 ~ 30Hz
5
No effect
42 Ramp up
85 Ramp down
128 Ramp up-down
171 Random
214 Lighting
255 Spikes
4
HQPOWER
Werbung
Inhaltsverzeichnis
