Fan; Error Display; Over-Temperature Protection; Ir-Halogen Lamp Fault - Wld-Tec SteriMax smart Bedienungsanleitung

clean the appliance with a spray-and-wipe disinfectant. The instrument itself must not be
sterilized.
!
Flaming the device is not possible.
After switching off, the fans (11) run until the excess heat has been dissipated.
i

7. Fan

Smart fan control ensures that even in continuous operation the temperature of the
housing does not rise above 65 degrees. As an additional safety mechanism, there is
a mechanical thermal circuit breaker.
After switching off, the fans (11) run until the excess heat has been dissipated.
i
!
Do not cover the ventilation grilles (10) and cooling fans (11) on the unit.

8. Error display

This section describes the error display "E1" and "E2" and gives you some advices for
solving them.

8.1 Over-temperature protection

"E1" appears on the timer display (5). Switch the device off by touching
the On / Off symbol (1) on the glass front for more than 2 seconds.
A new sterilization process can be only started after switching on after
the unit has cooled sufficiently (approx. 10 minutes).

8.2 IR-Halogen lamp fault

"E2" appears on the timer display (5). Switch the device off by touching
the On / Off symbol (1) on the glass front for more than 2 seconds. Only
after the device has cooled sufficiently, switch off the device using the
main switch (17) on the rear panel (switch position "0").
Before opening the device, remove the power plug (19) from the power outlet.
After switching off, the fans (11) run until the excess heat has been dissipated.
i
Now the IR-Halogen lamp can be changed. The removal and installation instructions
are included with the replacement halogen lamp:
IR-Halogen lamp, 230V AC:
IR-Halogen lamp, 120V AC:
IR-Halogen lamp, 100V AC:
28
Art.-No.: 4.001.100
Art.-No.: 4.002.100
Art.-No.: 4.003.100