Selecting The Sterilization Time And Cooling Time Reminder; Setting The Sterilization Time (Sun); Setting The Cooling Time Reminder (Snowflake); Sterilizing The Instrument - Wld-Tec SteriMax smart Bedienungsanleitung

2.4 Selecting the sterilization time and cooling time reminder

By briefly touching the timer symbol (2), the user can choose
between sterilization time (orange sun) (6) and cooling time
reminder (blue snowflake) (7).
After selecting the cooling time reminder (snowflake), if the
i
time is not changed within 2 seconds, the device returns
automatically to the sterilization time (sun).
2.5 Setting the sterilization time (sun) 5 - 10 seconds
The sterilization time can only be adjusted when sterilization is not
enabled. Keep pressing the timer symbol (2) until the desired sterilization
time is selected. The last displayed sterilization time is saved.
(Factory setting: Users 1 and 2, 10 seconds).
2.6 Setting the cooling time reminder (snowflake) 0 - 25 seconds
The cooling down time can only be adjusted when sterilization is not
enabled. By briefly touching the timer symbol (2), the display jumps from
the sun (6) to the snowflake (7).
Then keep pressing the timer symbol (2) until the desired cooling down
time is selected. The last displayed cooling down time is saved.
(Factory setting: 0 seconds = "-")

3. Sterilizing the instrument

This section describes the use and operation of the device for sterilizing inoculation
loops or small instruments.
EN
23