Stand-By Time; Insertion Mode; Factory Setting; Residual Heat Display - Wld-Tec SteriMax smart Bedienungsanleitung

touching the timer symbol (2). Keep the timer symbol (2) pressed and select ON ("1") or
OFF ("-") by releasing.
(Factory setting: ON = "1")
i
If no cooling time is selected, the buzzer is not activated automatically.

4.5 Stand-by time

If no sterilization is started, or any other settings made during the selected
stand-by time, the device switches itself off automatically, thus preventing
unwanted sterilization being activated during work breaks, for example.
This safety feature can be set to 15, 30 or 60 minutes. The settings menu
is activated by briefly pressing the button (14) on the back of the device.
Then select "SA" setting by briefly touching the timer symbol (2).
Keep the timer symbol (2) pressed and select 15, 30 or 60 minutes by releasing.
(Factory setting: 15 minutes)

4.6 Insertion mode

This function allows the user to leave the instrument in the sterilizing
orifice without holding it. After sterilization is complete, the instrument
can be removed without sterilization being restarted. The settings menu
is activated by briefly pressing the button (14) on the back of the device.
Then select "AL" setting by briefly touching the timer symbol (2). Keep
the timer symbol (2) pressed and select ON ("1") or OFF ("-") by releasing.
(Factory setting: OFF = "-")

4.7 Factory setting

The factory setting will reset the unit to its factory default state. This
resetting affects all parameters. The settings menu is activated by briefly
pressing the button (14) on the back of the device.
Then select "W" setting by briefly touching the timer symbol (2). Keep the
timer symbol (2) pressed and change from OFF ("-") to ON ("1") by
releasing. The device is now back in its configuration as delivered and
switches off automatically.
(Factory setting: OFF = "-")

5. Residual heat display

The residual heat display (3) lights up red and warns that the sterilizing
orifice is hot. The symbol is still displayed even after switching off until
the annealing tube has cooled down.
If the power supply to the unit is switched off at the power switch
i
(17), or the power cable is removed, the safety symbol cannot be
displayed even if the annealing tube is still hot.
26