The Range; Use; Safety Precautions - Wld-Tec SteriMax smart Bedienungsanleitung

The range

SteriMax smart - Inoculation Loop Sterilizer:
• 1 quartz glass annealing tube
(installed in the device)
• 1 replacement quartz glass annealing tube (R1)
• 1 inoculation loop holder (R2)
• 1 inoculation loop Ø 3 mm (R2a)
• Holding device for 3 WLD-TEC
inoculating loop holders (R3)
• Power cable (R4)
• 2 year warranty

Use

The SteriMax smart infrared inoculating loop sterilizer is ideal for laboratory
use for sterilizing inoculating loops, tweezers and micro-instruments made of
heat resistant materials such as stainless steel or platinum-iridium alloys.

Safety Precautions

• All users who have been assigned to use this device must read and
!
• When unpacking, check for possible shipping damage and do not
• Operate the unit only on a stable, non-slip and level surface.
• Do not operate the device near flammable liquids, materials or in
• Never insert instruments or objects where flammable liquids or material
• Operating conditions: Operating temperature 5°C to 40°C. Maximum
20
understand this manual or have been instructed by a competent
person in such a way that they can use this device without causing
danger.
operate if there is visible damage.
potentially explosive areas.
adhere to these instruments or objects into the annealing tube (9, 9a).
relative humidity 80% for temperatures up to 31°C decreasing linearly
to 50% relative humidity at 40°C.
230V / AC Art. No.: 4.001.000
120V / AC Art. No.: 4.002.000
100V / AC Art. No.: 4.003.000
R4
R2a
R2
R3
R1
Fig. D