Hameg HMS3000 Handbuch Seite 38

S t o r e a n d r e c a l l i n s t r u m e n t s e t t i n g s t
6.4.1 Screenshot example
In order to store data you have to defi ne the kind of data and the
destination. First attach a USB stick (refer to 8.1 USB connector)
to the front panel connector. Press SAVE/RECALL in order to call
the respective menu.
Fig. 6.7: Save/Load menu
Select the kind of data by pressing the respective soft key (in
this example SCREENSHOTS) in order to access the settings
menu.
Fig. 6.8: Menu with the settings for screenshots
Please verify that the USB connector into which you plugged
the USB stick (front or rear) is written in the top softmenu (you
can change the destination by opening the respective menu
if you press the softkey next to STORAGE). You can now save
a Screenshot if you press the softkey next to SAVE using the
predefi ned name written in the menu below FILE NAME. You
may name the destination memory with up to 7 characters; in
order to do this select the menu item FILE NAME and defi ne the
name by using the knob and the CURSOR SELECT key (in this
example PRINT).
38
Subject to change without notice
Fig. 6.9: Defi ning fi le names
After the softkey next to ACCEPT was pressed the oscilloscope
will have stored the name and return to the settings menu. Here
you can now store the actual screen display by pressing the
SAVE softkey. Alternatively, you can return to a lower menu level
(by pressing the lowest Menu OFF key) and select the menu item
key FILE/PRINT. In the following menu press the soft menu key
next to SCREENSHOTS: this will assign the function screenshot
to the key FILE/PRINT with the settings chosen. This enables
you to store a bitmap fi le on your USB stick by just pressing
FILE/PRINT at any time and in any menu.
Fig. 6.10: Settings of the button FILE/PRINT