Landing - SkyLine Zero Drag FR Handbuch

Adjusting the slider-retainer-line
While stretching your legs in the harness, the slider will be pulled by the slider-
retainer-line into the rear position. If the slider is in standard flight position, not at
rear stop, you have to shorten this line.
extensionplate!)
Length of the leg loops
The length of the leg loops is very important. If
too short, it can constrict running while start
and landing. If too long, the pilot could slip too
far to the back while straightening up and the
backplate could push the helmet from behind
upwards!
Leg loops with buckles are available in
different lengths, also with adjustable
buckles, Y-Type, H-Type or with T-buckle.

7. Landing

Open the main zipper with the left line in a sufficient flight level. The legs remain
still stretched. Near straightening up, legs are to be taken out of the harness, the
pilot has to push a little from the speedbar and thus he raises.
The pilot is now ready to run - now he can concentrate on grabbing the uprights.
(images are with Extensionplate!)
(Attention: Pictures are with optional
skyline-flightgear.de
10 10