Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FUNCTIONS
2 channels (CH A & CH B) selection for both TRANSMITTER and RECEIVER
3 levels of sensitivity adjustment for TRASNMITTER
Volume level adjustment for RECEIVER
Out of range LED indicator & beep warning (when RECEIVER is out of the
desired range from TRANSMITTER),
Low battery LED indicator and beep warning
Sound level LED indicator for RECEIVER
User selectable DIP SWITCH (8 combinations) to avoid interference from
other monitors working in same frequency band.
Vibration alert for RECEIVER (optional)
BASIC OPERATION
1.
Before operating this baby monitor for the first time, the 1.2V AAA
rechargeable batteries must be recharged for about 12 hours, then insert 3 -
batteries to both TRANSMITTER and RECEIVER. Alternatively, use the AC
adaptor to connect to both units.
2.
On both TRANSMITTER and RECEIVER, push the power button to turn on
the unit.
3.
Press and hold the menu button "M" until the channel LED "A" or "B" flashes,
press the up▲ or down▼ button to select the channel. Press the "M" button
again to confirm the selection.
4.
On TRANSMITTER, press and hold the menu button "M" until the sensitivity
LED flashes, press the up▲ or down▼ button to select the sensitivity level
you prefer. The sensitivity level will increase from low, middle to high along
with the 3 LEDs from left to right.
5.
On RECEIVER, press the up▲ or down▼ button to select the volume level
you prefer. The volume level will increase gradually as more LEDs light up
from left to right
6.
Have someone make some sound near TRANSMITTER, then the sound will
be heard through RECEIVER.
ILLUSTRATION
25
Werbung
