Inserting Slides - Philips SCD940 Bedienungsanleitung

1 Open the battery compartment (7) by turning the coin slot counter-
clockwise.Approx. 1/4 turn. For this use a coin.
2 Insert four AA batteries, noting the + and - configuration inside the
battery compartment
3 Put the battery compartment cover back in place.
4 Close the battery compartment (7) by turning the coin slot
clockwise.Approx. 1/4 turn. For this use a coin.
Using your Bedtime Magic Room projector
Positioning the Bedtime Magic Room Projector
• The Bedtime Magic Room Projector is fit for both wall and ceiling
projection and can be positioned under any angle.
• You will get the best image quality if you place the projector between 1.5
and 5m (1.6 and 5.5 yards). from the wall/ceiling.
• The best projection quality is achieved in a dark room.

Inserting slides

The supplied slides are designed for different ages of your baby.Your baby
will enjoy the projected images most if you choose an image that fits your
baby's age.
1 Take the slide holder (5) out of the projector.
2 Take the slide-wheel out of the slide holder and remove the printed disk
(slide) from the slide-wheel (1).
3 Insert the chosen slide into the slide-wheel. Make sure that the slide is
positioned under the tabs at the edge of the slide-wheel.
4 Put the slide-wheel back into the slide-holder (5).
5 Put the slide-holder back into the projector with the little knob facing
forward. Insert the holder unitil it clicks in position.
ENGLISH
5