AEG BSS 4801 Bedienungsanleitung Seite 27

Due to the different device manufacturers, models, and
software versions, a full functionality cannot be guaranteed.
• Logging on devices (Pairing)
Before you listen to music via the unit, you must pair the
devices.
1. Ensure, that the Bluetooth function is activated in
your player (e.g. mobile phone). For this, refer to the
operation manual of your player.
2. After turning it on, the indicator lamp (6) will flash to
show that the device is in pairing mode.
3. Keep the button (7) pressed down for approx. 3
seconds. You will hear two beeps. The devices can
now be connected to one another.
4. Chose the Bluetooth menu in your player and
register the device in your player. For this, refer to the
operation manual of your player. The device "AEG
BSS 4801" will show in your player as a selection.
NOTE:
Only one playback unit can be connected to the
speaker. If the speaker is already connected to
another playback unit, the speaker will not appear
in the BT selection menu.
5. Now enter the password "0000" in your player,
depending on the device manufacturers, model, and
software version.
If pairing was done successfully, you will hear a beep and the
indicator lamp (6) will light up.
For the further procedure, please refer to the user manual
of the playback unit. If possible, adjust the volume of the
external unit to a comfortable level.
NOTE:
• Depending on the device manufacturer, you need to
perform the registration (PAIRING) again to connect the
devices
• If you have problems in pairing a playback device,
deactivate the WiFi function / mobile data function in
your playback device.
• The Bluetooth compatibility cannot be ensured for
devices (e.g. mobile phones) getting released in the
future.
• To ensure an optimal connection, make sure that the
battery of your player is completely charged.
• Some of the mobile phone brands have an energy-sav-
ing mode. Deactivate the energy-saving mode as it can
otherwise result in problems during the data transfer
through Bluetooth.
• To be able to transfer audio data, Bluetooth needs to
stay activated in your player Observe the operation
manual of your player.
NOTE:
• If a mobile phone on which you are playing music
receives a call, the music will be interrupted. The sound
however is not played back via the speaker. After you
have ended the call, the devices are connected to
each other again and playback continues. The volume
increases slowly.
• Reconnecting devices
This device is designed to support automatic re-connec-
tion.
The following conditions must be met:
- the devices need to have been paired with each
other before
- Bluetooth is activated in your player
- your player supports this function
The automatic reconnection will be activated after the de-
vice has been switched on. This may last a few seconds.
If the registration has been successful, a beep will sound
and the indicator light (6) will light up.
Cleaning
CAUTION:
Do not submerge the device in water.
• Before cleaning disconnect from mains power supply.
• Clean the device with a soft damp cloth without deter-
gents.
Troubleshooting
Fault Cause
Unit cannot be Unit crashes
operated. and "hangs".
No audio signal Speaker is not
via the Bluetooth paired to the
connection audio source.
Volume too
low
Audio cable is
connected
English
27
Solution
Disconnect from the
mains for around 5 sec-
onds. Then switch the unit
on again.
Check whether a connec-
tion exists. If necessary,
pair the speaker again to
the audio source.
Increase the volume on
the speaker
Increase the volume on
the audio source.
Remove the cable from
the AUX IN socket (2).