Troubleshooting - AEG L 99696 DFL Benutzerinformation

WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 Introduction
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the Authorised
Service Centre.
CAUTION!
Deactivate the appliance before you do the checks.
With some problems, the acoustic signals operate and the display shows an alarm
message.
13.2 Possible failures
Problems with alarm messages
Message
The display tells to check the
tap: the appliance does not
fill with water.
The display tells to check the
drain filter: the appliance
does not drain the water.
The display tells to check the
door.
Possible solution
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
• Make sure that the water tap is not clogged or is fur-
red with lime-scale.
• Make sure that the filter of the inlet hose and the filter
of the valve are not clogged. Refer to "Care and
cleaning".
• Make sure that the inlet hose is not damaged.
• Make sure that the connection of the water inlet hose
is correct.
• Make sure that the drain hose is not damaged.
• Make sure that the drain filter is not clogged. Clean
the filter, if necessary. Refer to 'Care and cleaning'.
• Make sure that the connection of the drain hose is cor-
rect.
• Make sure that the appliance door is not open or
closed correctly.
ENGLISH 27