Clearaudio Tracer Bedienungsanleitung Seite 7

User manual / Bedienungsanleitung
Azimuth adjustments are made by loosening the small (1.5 mm) hex bolt (red marked screw) on the
bottom side of the armtube where the headshell enters the armtube. Once you loosen this screw,
you´ll be able to rotate the headshell a small amount in either direction. Be sure to tighten the screw
when done.
Pic. 6: Azimuth adjustment
You can adjust the tracking force of your cartridge by turning the adjustment screw
(shown in the picture below)
Green arrow = more tracking force (counter
Red arrow = less tracking force (clockwise)
Pic. 8: Tracking force adjustment
Made in Germany
Pic. 7: Screw to adjust the headshell
clockwise)/
7