Cleaning And Maintenance; Technical Specifications - HQ Power VDP3000ST Bedienungsanleitung

6. Remote Controller (optional)
The controller allows you to control the functions more easily. Connect the VDP3000RC to the fixtures
using a 3-pin XLR cable. The controller is able to control up to 20 fixtures. Remove the terminator from
the last VDP3000ST in the chain when using the VDP3000RC controller. Install a signal splitter after
the first fixture if necessary.
1. chase/sync toggle switch
2. intensity fader
3. blinder effect button
4. run/stop toggle switch
5. flash rate fader
6. single flash button

7. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting
supports, do not change the location of the connections.
3. Moving mechanic parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts.
8. Contact your dealer for spare parts if necessary.

8. Technical Specifications

power supply
power consumption
lamp
fuse
DMX512
dimensions
total weight
max. ambient temperature
optional controller
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
16.03.2010
VDP3000ST
max. 230VAC/50Hz
8A (33A peak)
®
Philips XOP 15-OF strobe lamp (order code LAMP3000ST)
F32A, 250VAC
1, 3 or 4 channels
246 x 425 x 240mm
7.5kg
40°C
VDP3000RC
7
Rev 01
©Velleman nv