Troubleshooting - AL-KO Snow Line 620 II Betriebsanleitung

GB

Troubleshooting

Caution!
Before troubleshooting, always switch off the engine and disconnect the spark plug connector.
Problem
Engine does not start.
Wheel drive does not work when clutch
lever is pressed.
Wheel drive cannot be stopped
(does not disengage).
Auger does not turn when clutch lever
is pressed.
Auger drive cannot be stopped
(does not disengage).
Machine vibrates excessively.
Machine pulls to one side.
32
Solution
Add petrol.
Set throttle to "Start".
Check the spark plugs and replace if necessary.
Clean discharge chute/housing.
Reduce operating speed.
Adjust control cable.
Switch off the engine.
Shear pin is broken, replace.
Adjust control cable.
Switch off the engine.
Check the skid plates; adjust or replace.
AL-KO snow blower
Translation of original user instructions