Adding Fuel And Engine Oil - AL-KO Snow Line 620 II Betriebsanleitung

GB
4. Insert the guide plates into the discharge chute
( 12-1).
5. Repeat the procedure for the other two guides
» The snow discharge chute is attached.
Attaching snow discharge chute hand crank
1.
2.
below into the guide on the guide handle (
3.
15).
using pliers (
4. Insert the hand crank into the lower guide on the
snow discharge chute. The snow discharge chute
the upper guide. To do this, loosen the screws
slightly and re-tighten after adjusting (
5. Attach the washer and insert the safety split pin
using pliers ( 17-1).
6. Bend the ends of the safety split pin (
7. Screw the handle onto the crank (
» The hand crank is attached.
Checking the tyre pressure
the tyres ( 20-1)
Attaching the headlight (620E II)
1.
( 21-1)
2. Fasten the headlight using the washer and self-
locking nut.
3. Fasten the cable to the guide handle using cable
clips.
» The headlight is attached.
26
( 13).
( 16-1).
14-1).
18).
19).

Adding fuel and engine oil

Always follow the instructions in the engine
Fuel the snow blower and add oil before use.
Fuel and lubricant
14).
Type
Filling
quantity
AL-KO snow blower
Petrol Engine oil
Regular lead-free SAE 5W-30
petrol (86 octane
or higher)
Engine is E10-
Translation of original user instructions