Storage; Repairs; Replacing The Shear Pins; Disposal - AL-KO Snow Line 620 II Betriebsanleitung

Snow Line 560 II, 620 II, 620E II
Maintaining the auger drive
Adjusting the control cable
If the auger drive no longer engages when the engine is
Caution!
Switch off the engine before adjusting the con-
trol cable.
1. Loosen the lock nut (
2.
direction of the arrow (
the clutch lever is pressed. Hold the cable while
tightening so that it does not twist.
3. Tighten the lock nut.
4.
engaging the auger drive.
5. If the auger drive still does not engage and

Replacing the shear pins

If the auger is blocked, the shear pins (
break in order to ensure safe operation.
Replace broken shear pins with original re-
1.
plug connector.
2.
3.
4. Insert new shear pins and secure with safety split
pins ( 42-1)..
469186_c
41-1).
41-2) until the control
25-1)
-
( 42-2).

Storage

Danger - risk of explosion!
heat source.
-
Start the engine.
Close the fuel tap.
Wait until the engine dies.
Allow the engine to cool.
Store in a dry area that is inaccessible to children
and unauthorised persons.
Disconnect the spark plug connector.

Repairs

After running onto an obstacle.
If the engine stops suddenly.

Disposal

Do not dispose of worn-out machines,
batteries or rechargeable batteries in the
household rubbish!
of accordingly.
GB
-
31