Getting Ready For Operation - AL-KO Snow Line 620 II Betriebsanleitung

Snow Line 560 II, 620 II, 620E II
Safety
Warning!
Never leave the engine running in an enclosed
space. Risk of poisoning!
Store petrol and oil only in appropriate containers.
enclosed space.
there is no ignition source in the enclosed space,
such as a heater or clothes dryer.
when the engine is switched off and cold.
Do not open the tank cap while the engine is run-
ning or hot.
Always secure the tank cap securely.
If petrol has spilled out:
Do not start the engine
Collect spilled petrol with a binding agent or
cloth and dispose of appropriately.
If engine oil has spilled out:
Do not start the engine
Collect spilled petrol with an oil binding agent
or cloth and dispose of appropriately.
When disposing of used oil:
do not throw into the rubbish
do not pour into sewers or drains or onto the
ground
to a recycling facility or service centre.
469186_c
Adding engine oil
1.
area.
2. Add oil using a funnel.
3. Check the oil level.
4. Replace the oil cap tightly and clean.
the oil level.
Adding petrol
1.
clean area.
2. Add petrol using a funnel.
3. Replace the tank cap tightly and clean.

Getting ready for operation

Caution!
ences the illustrations on pages 4–7.
Adjusting the clearance height
Danger - risk of injury!
Adjust the clearance height only if the engine
Adjust the clearance height to avoid taking
in gravel or other objects.
Look out for uneven places such as ruts,
1.
2.
( 23-1).
3. Raise the clearing plate to the desired height and
attach the skid plates. Make sure that both skid
plates are spaced equally so that the clearing plate
runs parallel to the ground (
GB
22 -1) and store in a clean
22 -2) and store in a
23-2).
-
27