Sunred GS11 Handbuch Seite 4

Operation
Connect the power cable to a 13 amp supply that is located in a safe, dry area.

The switch on the heater head is used to control the three heat settings. (I) for 900W – (II) for 1200W – (I&II)
for 2100W. When the timer is in the "ON" position, the heater will be on continuously.

Although the patio heater is weather proof, do not use when raining or in wet conditions.

Always disconnect the power cable from the electrical supply when the patio heater is not in use.
Care and maintenance

Unplug the unit and let it cool completely.

To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild
detergent if necessary. After cleaning, dry the unit with a soft cloth.

DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This
may cause damage or deterioration to the surface of the heater.

Although this heater is outdoor approved, DO NOT immerse the heater in water for your safety.

Wait until the unit is completely dry before use.
Storage

Ensure the unit is completely cold before storing in a cool, dry location.

To prevent dust and dirt to build-up, use the original packaging to repack the unit.

CHOKING HAZARD: Store out of reach of children and pets. Contains small parts.
Disposal

DO NOT dispose of the unit via your weekly household waste collection service. ONLY dispose of this product
at your local, licensed recycling/waste centre.

For further information on the disposal of electrical goods, please contact your local authority.
Trouble shooting

If the heater will not operate, please check the following before seeking repair of service:

Check if the power cord is plugged into an electrical outlet; if not, plug in.

Check if electricity to the main fuse is working.

Make sure the power switches are turned on. If not, choose a heat setting.
Technical specification
•
Power supply 230V~ 50Hz
•
Wattage max 2100W
•
Net weight 14.6 kg
•
Insulation class I
•
Height max 208 cm
Assembly
Step 1: Fix the Bottom Tube to the Base using three M6*50 bolts.
Step 2: Place the Decoration Cover onto the Bottom Tube.
www.sunred.nl