Show Set Parameters: Mr Hei-Tec, Mr Hei-Connect; Start Heating - Heidolph MR Hei-Standard Betriebsanleitung

Operation
MR Hei-Tec, MR Hei-Connect
✓ Actual temperature is shown in the
display.
➜ Choose temperature setting with select
knob.
✓ Temperature setting is marked with a
frame.
➜ Press select knob within 3 seconds.
➜ Set required temperature by turning
select knob.
➜ Press select knob or wait 3 seconds.
✓ Set temperature is saved.
✓ The actual temperature appears in the
display.
If no entries are made within 3 seconds the last entry will be saved
and the display switches to show actual parameters.
Working with external temperature sensor Pt 1000:
The display shows "ext" in addition. Setting temperature is exactly
the same procedure.

Show set parameters: MR Hei-Tec, MR Hei-Connect

✓ Device is switched on.
✓ Display shows actual parameters for speed and temperature.
➜ Press select knob and hold pressed.
✓ Display switches to show set parameters.

Start heating

✓ Vessel with sample and stirring bar is
placed on hotplate.
✓ Device is switched on.
➜ Press heating button.
✓ Heating button illuminates.
✓ Heating starts immediately.
✓ The actual temperature is shown in the
display.
Temperature setting: framed
Heating button
Heating off
16
Select knob
Heating on