Start-Up
Setting up device
Warning:
Magnetic field!
The magnetic field beneath the hotplate could cause irritations with
cardiac pacemaker if you get too close.
Personnel with a cardiac pacemaker, implanted defibrillator or dosing
pump should keep a minimum distance of 10 cm (4 inches) to the
device.
Warning:
Risk of slipping device!
As a result of vibrations generated during operation the device might
slide off the table top.
The surface must be smooth, clean and temperature resistant and
should be properly leveled.
➜ Locate the shaker on a stable, horizontal surface.
➜ Clean surface and feet with a damp cloth and ethanol regularly.
Connect/disconnect power cord
Connect power cord
The power cord comes with a three-wire
plug and recess on the bottom side.
The socket is located on the back side of
the unit.
➜ Connect plug to the socket with the
recess facing down.
➜ Push plug up against socket until
securely attached.
➜ Connect plug to power socket.
Disconnect power cord
➜ Disconnect plug from power socket first.
➜ Then disconnect plug from socket on unit.
Start-Up
Unit plug
Unit socket
11
Power cord