Operating Elements And Connections - Omnitronic DYN-220 Bedienungsanleitung

4 4 4 4 Operating Elements and Connections

1 2
10
The operating and connector panels for channel A and B are identical.
No. Element
1 INPUT LEVEL indicator
2 GATE THRESHOLD control
3 COMPRESSOR THRESHOLD
control
4 COMPRESSOR RATIO control
5 GAIN REDUCTION meter
6 BYPASS button
7 OUTPUT LEVEL control
8 LINK button
9 POWER switch
10 Power input with fuse holder
11 OUTPUT jacks
12 INPUTS jacks
13 -10dB/+4dB switch
A
3 4 6 7
5
11 12
Function
LED level indication for the input signal (+4dBu = rated level, OL =
overload).
Adjusts the threshold for the gate: If the input signal exceeds the
threshold, the signal will pass unchanged. If it falls below the
threshold, it will be attenuated with a ratio of 2:1. An LED
indicates the signal processing.
Adjusts the threshold from where the signal is to be compressed.
An LED indicates the signal processing.
Adjusts the compression ratio (1:1 to
Displays the level reduction by the compressor.
Depress this button to bypass the compressor and send the input
signal to the output unchanged. If the button is released, the
signal processing will be active. Note that the bypass mode works
independently for each channel, even if the channels are coupled.
Adjusts the output level.
Depress this button to couple both channels, i.e. the adjustments
in channel A will also be effective for channel B (stereo mode). If
the button is released, both channels will operate independently.
Turns power to the unit on and off. When powered on, the
adjacent indicator lights up.
Plug in the supplied power cable here. Only replace the fuse
when the device is disconnected from mains. Only use fuses of
the same rating and power. The correct fuse value is specified on
the rear panel.
The output section of each channel features balanced XLR and
6.3 mm jack connectors, wired in parallel.
The input section of each channel features balanced XLR and 6.3
mm jack connectors, wired in parallel.
For internal level matching. Position "+4dB": for line levels in
studio applications. Position "-10dB": for line levels in home
recording applications.
8
13
15 • EN
B
∞
:1).
9