Use Of Signal Outputs; Further Analysis - Gigahertz Solutions HF59B Bedienungsanleitung

Made in Germany
is also available as audio sample on our website (see "Sound Sam-
ples").
Note concerning the switch setting "Pulse":
Under special laboratory conditions a signal can be created, which causes an addi-
tional deviation from the actual value of up to -3 dB. However, commercially used
modulations under field conditions will only show minimal deviations.

Use of Signal Outputs

AC output:
The AC output "PC/headset" (3.5 mm jack socket) is meant for an in-
depth analysis of the AM/pulsed content of the signal by headset or
a corresponding PC-audiocard.
DC output (2.5 mm jack socket):
The DC output is meant for a long-term recording of the display value.
If "Full Scale" is displayed, it has 1 VDC output.
The auto power off function is automatically deactivated as soon as
external devices are connected, but only as long as there is no threat
of total discharge.

Further Analysis /

Optional Accessories:
Available from Gigahertz Solutions:
The amplifier HV10 for a particularly high resolution, allowing
measurements of very weak HF signals.
The Attenuator DG20_G10 allowing the measurement of very
strong HF signals.
A Frequency filter for a more specific differentiation of the various
sources.
Meters for HF from 2.4 to 6 or 10 GHz allowing the analysis of
even higher frequencies, i.e. the HFW35C (2.4 - 6 GHz) or the
HFW59D (2.4 - 10 GHz)
Meters for the low frequencies: With the NFA series, which allows
a three-dimensional measurement of alternating electrical and
magnetic fields, Gigahertz Solutions offers a broad range of profes-
sional measurement technology also for this frequency range.
Data loggers: All NFA meters can equally be applied as data log-
gers for long-term recordings.
Seite 36 © Gigahertz Solutions GmbH