Bellcome advanced 1 Familie Benutzerhandbuch Seite 29

7.2 Use of the video terminal
1 STAND-BY
The keyboard is not backlit.
At the first touch, the keyboard is backlit and the terminal may receive the
following commands:
By touching this key, you may see and listen to what goes on at the entrance, in
Stand-by
front of the outdoor panel. Monitoring is not possible if another terminal of the
system is being called or is during communication.
//If several video cameras are installed within the system, the successive stroke
of the key changes the camera through which the monitoring is done.
By successive touches of this key, the 3 volume levels are passed through:
maximum (white LED), medium (red-white LED) and turned off (red LED). The red
LED will remain permanently turned on until the key is pressed again.
2 CALL AND COMMUNICATION
Call duration: maximum 1 min.
The LED of the key blinks and the display shows the image sent by the video
camera of the outdoor panel.
By touching the key, communication is initiated. The LED does not blink anymore.
Call
Do not touch the
The second touch of the key ends communication without granting access and
the terminal returns to stand-by mode.
3 ACCES
After the command, the lock is unblocked for 1...10 sec. for the access of
the visitors.
// You cannot grant access without having a prior communication.
Communication
4 AUX COMMAND
No matter what the state of the terminal is: monitoring, call or
communication, this key may action an automation connected to the
system: auto access or garage gate, lighting system etc.
AUDIO – VIDEO MONITORING
+ VIDEO CAMERA SELECTION
Monitoring duration: 10 sec..
VOLUME ADJUSTMENT OR
"TERMINAL TURNED OFF"
ANSWER THE CALL
Communication duration: maximum 2 min.
key during communication.
END COMMUNICATION
WITHOUT ACCESS!
ACCESS AND
END COMMUNICATION!
AUXILIARY COMMAND
29/96