Commisioning Of The System - Bellcome advanced 1 Familie Benutzerhandbuch

5.2 Connection of the auxiliary command (optional)
6

COMMISIONING OF THE SYSTEM

6.1 Description of the supply control unit
The supply control unit includes:
*PROG. : programming button
*The kit does not require
programming. This button is used
only if you add additional
terminals or panels to the system.
RED signaling of PROG
= defect within the system
TIME:
Lock timing adjustment
6.2 The checking of connections in the system and
the connection of the supply control unit
Check the precision of the connections in the system!
The +14V , GND , CD , GNV and Uv signals are common to all components of the system.
The Vin and Vout signals are specific to each terminal or video camera (they are not to be
connected jointly).
Any short circuit between them leads to the non-operation of the entire system.
With an ohmmeter, check that there is no short circuit between any hubs, anywhere in the system.
Connect the supply control unit to the 230 V a.c. network, by connecting the two automatic
10A fuses, installed on phase and null.
Optionally, connect the accumulator to the +ACC and –ACC hubs of the supply control unit.
PAY ATTENTION to the polarity of the accumulator!
Check the existence of the supply tensions with the values mentioned below, at the hubs of
the supply control unit (use a drive current voltmeter).
Tensions measured at the hubs of the supply contol unit : +14V – GND /13,8 ... 14,3Vd.c.

Tensions measured at the hubs of the outdoor panel and at the hub of the terminal:

Relay contact
Maximum switched current: 1.5 A
Automation
S1: presence of tension
at the +14V - GND hubs
S2: existence of tension
at the +Uv - GND hubs
Protection lid for connections
Front lid
Protection lid for connections
+Uv – GND /13,5 ... 14,3Vd.c.
+ 14V - GND min. 12 Vd.c.
+ Uv - GND min. 12 Vd.c
anywhere
in the system
25/96