Radio Interference - ACP 20152601 Bedienungsanleitung

Installation & Cleaning
Unpacking Oven
• Inspect oven for damage such as dents in door or inside oven cavity.
• Report any dents or breakage to source of purchase immediately.
Do not attempt to use oven if damaged.
• Remove all packing materials from oven interior.
• If oven has been stored in extremely cold area, wait a few hours
before connecting power.
• A protective film is used to prevent scratching of the outer case during
transportation. Peel off the film from the exterior of the oven before
installation.
• The warning label provided with the oven must be placed in a
conspicuous location near the oven.

Radio Interference

Microwave operation may cause interference to WiFi network, radio,
television, or a similar oven. Reduce or eliminate interference by doing the
following:
• Clean door and sealing surfaces of oven according to provided
instructions.
• Place WiFi network, radio, television, etc. as far as possible from oven.
• Use a properly installed antenna on radio, television, etc. to obtain
stronger signal reception.
Oven Placement
Do not install oven next to or above source of heat, such as pizza
•
oven
or deep fat fryer. This could cause microwave oven to operate
improperly and could shorten life of electrical parts.
• Do not block or obstruct oven filter. Allow access for cleaning.
• Install oven on level countertop surface.
• Outlet should be located so that plug is accessible when oven is in
place.
To avoid risk of electrical shock, severe personal injury or death,
unplug power cord or open circuit breaker to oven before cleaning.
Cleaning Interior, Exterior, and Door
Clean microwave oven daily with mild detergent in warm
water using soft sponge or cloth. Wring sponge or cloth to
remove excess water before wiping equipment. If desired,
boil a cup of water in microwave oven to loosen soil before cleaning.
DO NOT allow cooking residues such as grease or fat to remain
in oven interior for any length of time.
• Do NOT allow cooking residues to remain in oven cavity.
• Do NOT use abrasive cleansers or cleaners containing
ammonia.
These could damage finish.
• Do NOT use caustic cleaning products or those containing
ammonia, phosphates or chlorine in oven. These could damage
oven. Use non-caustic cleaner.
• NEVER pour water into microwave oven bottom.
• Do NOT use water pressure type cleaning systems.
• For more detailed cleaning instructions, see the Owner's
Manual on-line at www.acpsolutions.com.
SAVE THESE INSTRUCTIONS
Part No.20152601
Revised 8/15
CAUT IO N
To avoid risk of electrical
shock or death, this oven
must be grounded and plug
must not be altered.
Grounding/Earthing
Instructions
electric current, if an electrical short
occurs. This oven is equipped with
a cord having a ground wire with
a grounding plug. The plug must
be plugged into an outlet that is
properly installed and grounded.
Consult a qualified electrician or
servicer if grounding instructions
are not completely understood, or if
doubt exists as to whether the oven
is properly grounded.
Do not use an extension cord.
If the product power cord is too
short, have a qualified electrician
install a three-slot receptacle. This
oven should be plugged into a
separate circuit with the electrical
rating as provided in product
specifications (available on ACP's
website at www.acpsolutions.com).
When a microwave oven is on a
circuit with other equipment, an
increase in cooking times may be
required and fuses can be blown.
External Equipotential
Earthing Terminal
Equipment has secondary earthing
terminal. Terminal provides
external earthing connection used
in addition to earthing
prong on plug. Located
on outside of oven
back, terminal is
marked with symbol
shown below.
4
WARNING
MUST
Oven be
grounded. Grounding
reduces risk of electric
shock by providing an
escape wire for the
(export only)
 2015 ACP, Inc.
Cedar Rapids, Iowa 52404