Changing User Options - ACP 20152601 Bedienungsanleitung

Mid-Cycle Cooking Pause
To add a pause to a programmed cook
cycle:
1. Press HIDDEN PAD after entering
time or power level.
2. A short beep sounds. This indicates
the program is set for a mid-cycle
pause.
3. Continue programming pad as
desired.
To remove a pause from a
programmed cook cycle:
1. Press HIDDEN PAD after entering
time or power level.
2. A short beep sounds. This indicates
that the mid-cycle has been
removed.
3. Continue programming as desired.
Hidden Key Pad

Changing User Options

Options such as single and double pad programming or beep volume can be changed
to suit individual preferences.
If oven has just been turned on, door must be opened and closed before
proceeding:
1. Press firmly on hidden pad located to the right of the STOP keypad.
• Pad is unmarked
• The display remains the same when hidden pad is pressed
2. Press PROGRAM SAVE pad.
• The first user option will display. Oven is now in options mode.
3. Press desired number pad to control changes in options.
• See table on next page for options
• Current option will display
4. Press the same number pad again to disable or enable the setting.
• Each time the pad is pressed the option will change
• To change additional options repeat steps 3 and 4
5. Press PROGRAM SAVE to return to READY mode, changes take effect
immediately. To exit without saving, press the STOP pad.
Part No. 20152601
Printed in U.S.A. 8/15
Original Instructions
Programming Oven Controls
Using the USB Flash Drive
1. READY must be in the display. If not, open and
close door.
2. Open the oven door completely.
3. Insert USB flash drive.
4. Press and hold the 5 pad until "USB" appears on the
display.
5. To transfer programming FROM the USB flash drive
TO the oven, press the 1 pad.
• Or to transfer programming TO the USB flash
drive FROM the oven, press the 2 pad.
6. Push the START pad to begin transfer.
• Display will read, "Contacting USB card."
• Display will then read, "Transferring data from
USB to oven," or vice versa.
7. Once programming has been successfully
transferred, display will read, "Done - Loaded ___
Programs."
• Shut the door to clear the display and begin
cooking cycle
8. Error codes:
• No file: USB flash drive is empty or does not have
the correct file(s) required for operation.
11
5
.
1
 2015 ACP, Inc.
Cedar Rapids, Iowa 52404