Programming Oven Controls - ACP 20152601 Bedienungsanleitung

Programming Oven Controls

Programming Pads
Oven is shipped from the factory set for single pad programming. To
change the oven default to double pad programming, see User Option
section. To program the amount of time or power level setting for a pad:
1. READY must be in the display. If not, open and close door.
2. Press PROGRAM SAVE pad.
• Programming mode begins
• "Enter Program to Add/Review" displays
3. Press desired number pad to be programmed.
• Display will show all settings for the pad
• The pad number that is being programmed displays beside
the word ITEM
4. Press TIME ENTRY to program amount of cooking time.
• Enter desired cooking time by using numeric key pads
• Maximum cooking time is 60 minutes
5. Press POWER LEVEL to program level of microwave power.
• For a lower microwave power, press pads 1 (for 10%)
through 9 (for 90%)
• Press numeric key pad for desired level. Press same
numeric key pad again to set power level to 100%
6. Press PROGRAM SAVE to save changes.
7. To discard changes, press STOP/RESET.
Programming Multiple Stages
Stage cooking allows consecutive cooking cycles without interruption.
Up to four different cooking cycles can be programmed into a memory
pad.
To use stage cooking:
1. Follow steps 1 through 5 above.
6. Press STAGE.
• This will begin programming for the next cooking stage
• Display indicates stage to be programmed
• Enter cook time and power level as in steps 4 and 5
• To enter another cooking stage for that pad, press STAGE
pad again
• Up to four different stages can be programmed
• Total cooking time (all stages totaled) is 60 minutes
7. Press PROGRAM SAVE to save the programming and changes.
8. To discard changes, press STOP/RESET before pressing
PROGRAM SAVE.
Part No. 20152601
Printed in U.S.A. 8/15
Original Instructions
0
.
1
2
3
4
10
Programming Top &
Bottom Only Cooking
1. Push the POWER LEVEL pad.
Select and program the
preferred microwave power.
2. If the POWER LEVEL pad is
pushed a second time, "Top Only"
heating option will be selected and
displayed.
3. If the POWER LEVEL pad is
pushed a third time, "Bottom Only"
heating is selected and displayed.
4. If the POWER LEVEL button is
pushed a fourth time, the oven
resets and both top and bottom will
heat.
Top Only Cooking
Manual Stage: 1
00:00 MW: 50%
Flashing
Bottom Only Cooking
Manual Stage: 1
00:00 MW: 50%
Flashing
Top and Bottom Cooking
Manual Stage: 1
00:50 MW: 100%
Flashing
Cedar Rapids, Iowa 52404
 2015 ACP, Inc.