Remington HC5900 Handbuch Seite 9

ENGLISH
, EVERY SIX MONTHS
• Remove the 2 screws retaining the fixed blade with a screwdriver. Do not
remove blade set.
• Brush out hairs from between the blades with soft cleaning brush. Do not
remove the lubricating grease from the blades. It is not necessary to
remove the small moving blade from the unit.
• If the moving blade has been removed this can be re-fitted by slotting the
coated blade holder over the pin in the centre of the interior product head.
• The groove on the coated blade, just below the teeth, rests on a metal plate
at the opposite side to the screw holes. The fixed blade is fitted with the
raised profile pointing outwards and fixed with the 2 screws.
• If the blades are not correctly aligned, cutting efficiency will be impaired.
, CLEANING CAUTIONS
• Ensure the appliance is switched off and unplugged from the mains before
cleaning.
• Do not use harsh or corrosive cleaners on the units or their blades.
BATTERY REMOVAL
• The appliance must be disconnected from the supply mains when
removing the battery.
• Turn the trimmer on and discharge all remaining power.
• Remove the comb attachment.
• Detach the blade cartridge.
• Pry the decorative panel off the top housing to expose the 6 screws located
in the inner housing.
• Unscrew the 6 screws.
• Pry the inner housing apart from bottom housing to expose the internals
and printed circuit board.
• Remove the battery and printed circuit board assembly from the battery
chamber.
• Disconnect the battery from the circuit board.
• The battery is to be disposed of safely.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous
substances in electrical and electronic goods, appliances marked with
this symbol must not be disposed of with unsorted municipal waste,
but recovered, reused or recycled.
9